eKbin: 80Hz - 200Hz Kickbass

Hi,

I plan to build a kickbass bin with the dimensions 60x65x75 to fit well on a X1 (60x77x80).

The design is somehow an USB or ES18BPH.

This is the simulation:

And the settings:

Any hints or ideas about it?


Regards,
engel

you will need to sim this in 4pi, allso look at a combined response of 2 cabs, i take it you will be running 2 a side.....

bee wrote: you will need to sim this in 4pi, allso look at a combined response of 2 cabs, i take it you will be running 2 a side.....

yes my fault - should be 4Pi

any idea how to flatten that 220Hz peak?

If I build the eKbin stand apart (like two single USB bins) and stack them as a monoblock ontop of the two X1 - would Pi be 2 or 4???

I plan to run only two X1 and two eKbin as a monoblock because the location is not very wide...

you would still sim the kick cab as 4pi, ill have a little play and see what i can come up with..... you can sim in 2pi but this would mean floor stacking the kick cab......

i dont think you are combining the response of two cabs together, this is what i came up with, with your input data..... this is 2 of your kick cabs next to each other.....

So this would be a monostack of two X1 with two eKbin ontop:

that is correct, ive managed to get a bit more spl by making the rear chamber smaller by a few litres.......