hog scoop

am trying to build a hog scoop was wondering, i made the conversion from millimeter to inches but round it off to a whole number for instance 950mm i put it as 37inches instead of 37.4015748 would that be a problem or am i doing it the right way ....your help will be greatly appreciated

your best bet would be to draw the cab to scale on some graph paper, you may need to stick a few sheets together, that way you will get all the bits to fit, your best bet would be to build to the exact measurements, do you have a tape measure in mm........

thanks for the quick reply ...guess i will have to find a tape measure in millimeters cause i don't have one

lol where are u based in the world.....

I'm in the US and went to lowes to find a tape metric measure. There is a 10'x15' wall of nothing but tape measures and after 20 minutes I finally found the ONE.

smiley32 smiley36

classic.... so whats stopping you, time to get cutting.....

37.4 inches will put you way out as the 0.4 inches revert to about 6mm and can cause a lot of frustration and headaches. Glad you found the metric tape. Get yourself a steel ruller that is metric as well if you can find one.