- Posts: 15
- Thank you received: 0
Cubo Sub
- Tetris
- Offline
- New Member
Less
More
1 year 5 months ago #25041
by Tetris
Replied by Tetris on topic Cubo Sub
Over 6 years since I asked, I've FINALLY got round to starting my RCF LF18X401 powered Cubo Subs! Unfortunately due to the astronomical cost of birch ply now, I've gone for MDF, but one is nearly finished and am excited to see the results! Have incorporated handles into the bottom bracing which I hope won't affect things too much, but after years of negotiating stairs, I felt this was a necessary compromise! Will post updates when ready (don't hole your breath)
Attachment not found
Please Log in or Create an account to join the conversation.
- Zambrotta
- Offline
- New Member
Less
More
- Posts: 14
- Thank you received: 0
1 year 4 months ago #25045
by Zambrotta
Replied by Zambrotta on topic Cubo Sub
Hello cubo is there a plan for a dual cubo sub 18
Please Log in or Create an account to join the conversation.
- Cubo15
- Topic Author
- Offline
- Platinum Member
Less
More
- Posts: 916
- Thank you received: 131
1 year 4 months ago #25047
by Cubo15
Replied by Cubo15 on topic Cubo Sub
There actually is, send me an e-mail at questionsaboutcubo at gmail dot com
Please Log in or Create an account to join the conversation.
- shem1
- Offline
- New Member
Less
More
- Posts: 5
- Thank you received: 0
1 year 1 week ago #25063
by shem1
Replied by shem1 on topic Cubo Sub
HI Mr cubo could i make the cubo sub 660mm wide instead of 620?
Also what hpf would i need on the cubo sub running a pd186 mk1 in it?>
Also what hpf would i need on the cubo sub running a pd186 mk1 in it?>
Please Log in or Create an account to join the conversation.
- Cubo15
- Topic Author
- Offline
- Platinum Member
Less
More
- Posts: 916
- Thank you received: 131
1 year 1 day ago #25064
by Cubo15
Replied by Cubo15 on topic Cubo Sub
HI,
You can adjust the width to 660 mm, without any issues. I would set the high pass at 20 - 30 Hz (experiment a bit with frequency and slope untill it sounds just right), if you're going for maximum power/ output 30 Hz is better.
You can adjust the width to 660 mm, without any issues. I would set the high pass at 20 - 30 Hz (experiment a bit with frequency and slope untill it sounds just right), if you're going for maximum power/ output 30 Hz is better.
Please Log in or Create an account to join the conversation.
Time to create page: 0.216 seconds