USB

its on the link directly above your last post.....

can i ask for some help. we built a couple and when we tested it. it blew the drivers

what was your high pass set too......

Afternoon all,

My father and i have decided to try and attempt to build a couple of USB speakers as a little project over the next few weeks. Ive downloaded the plans and redrawn them in AutoCAD (i was bored. lol) to work out the remaining dimensions and angles ect.

No doubt ill have a few question for the members here in relation to this build over the next few weeks, but my first few are:-

1) What is the best way to wire USB's if they were to be used with their intended Labsub speakers, is using NL4MP. (could some explains the wiring to me in basic laymans terms lol)

2) I have redrawn the USB's with bar handles in the access panel, would this be ok? the bar handles are the self contained type, and i would be gluing and screwing them in to place so as to completely seal them?

3) Does anybody still make router templates for these ? any prices knocking about ?

Regards
Chris

can I make one half of it? Will it still possess all of its sound quality except for the halved reduced spl and bottom end response?

hello, sir i really love your design, and i think it would be a perfect addition to my existing system. so is it possible to get some nice planes for rebuilding it? thank you very much in advance ! kind regards alex

can some one help me find 4 flat packs of the usb bins to buy

Hi,

Does any one no the best way to wire the USB? Sure i see details on the forum before but can not find them anymore

Any help appreciated

Wayne

can anyone send me a cut list for 2 usb?? would be a great help

positive on speakon to negative on driver, the usb needs to be wired in reverse.....