- Posts: 1
- Thank you received: 0
bass bins sizes..
- menxmen
- Topic Author
- Offline
- New Member
but my problem is its size, big and heavy too,but sound loud too..
Please Log in or Create an account to join the conversation.
- sn95
- Offline
- Premium Member
- Posts: 127
- Thank you received: 13
Please Log in or Create an account to join the conversation.
- Rog Mogale
- Offline
- Premium Member
- Posts: 120
- Thank you received: 19
If not then put each cab on a large table saw and cut them in half. Your have to do the internal panels by hand with a wood saw, (any better suggestions Bee about how to cut the internal panels). Then gule and screw on 2 new sides.
An 18" scoop is more transportable but one 18" scoop is not going to have anywhere near the output of a well loaded 4520. Two single 18" scoops vs one 4520, I'll take the two single 18" scoops any day.
Rog.
Please Log in or Create an account to join the conversation.
- sn95
- Offline
- Premium Member
- Posts: 127
- Thank you received: 13
Please Log in or Create an account to join the conversation.
- Reality Sound
- Offline
- Elite Member
- Posts: 305
- Thank you received: 10
Please Log in or Create an account to join the conversation.
- bee
- Offline
- Platinum Member
- Posts: 2090
- Thank you received: 34
Rog Mogale wrote: If they are original JBL 4520's, then sell them for like 50 million dollars to a Hi Fi nut and retire or employ lots of helpers.
If not then put each cab on a large table saw and cut them in half. Your have to do the internal panels by hand with a wood saw, (any better suggestions Bee about how to cut the internal panels). Then gule and screw on 2 new sides.
An 18" scoop is more transportable but one 18" scoop is not going to have anywhere near the output of a well loaded 4520. Two single 18" scoops vs one 4520, I'll take the two single 18" scoops any day.
Rog.
a router.... cut cab in half as said, and cut internal panel by hand, leave a bit of overhang. then turn cab up on end (not cut) place a 36mm piece of wood across where cuts were made. use a long length router cutter, aligned to edge, and trim perfect.
Please Log in or Create an account to join the conversation.
- Bongo
- Offline
- Junior Member
- Posts: 24
- Thank you received: 1
But there's more to it than that.
Basshorns are big & you won't go really deep with a single horn unless it's very big.
Horns are great in groups, big added spl & low end.
Bandpass horns are smaller, but also best in stacks or for "kickbins"
For single use, bassreflex, bandpass or tapped horn is the best choice, but you won't gain as much when stacking.
I like the sound of horns, I think reflexes "hurt" more, the acoustics seems to be quite different too.
Some says horns have more "throw" by this I think they mean directivity, I experienced less feedback on basshorns than reflexes, probably due to this. On inside jobs your horns will probably go lower due to "room response"
Please Log in or Create an account to join the conversation.